Box 02 · Guide

How to pack a moving truck so nothing shifts

Load a rental moving truck the way experienced crews do: heavy pieces first, tiers floor to ceiling, tie-offs every few feet, and nothing loose at the door.

By The Moving Labor team · · 4 min read

A well-packed truck looks like a wall of furniture and boxes built in layers from the front of the box to the back, each layer tight to the ceiling and strapped to the side rails. The goal is simple: nothing should be able to move more than an inch when the driver brakes hard. Furniture rarely breaks from being carried. It breaks from sliding into something during the drive.

Before anything goes on the truck

Stage the load. Put boxes near the door grouped by weight, and pull furniture into the rooms closest to the exit if you can. A crew that can see everything plans the load better than one discovering a piano in the basement at hour three.

Gather what you'll need inside the truck: furniture pads (most rental places have them for a few dollars a dozen), a couple of ratchet straps or rope, stretch wrap, and a box of tools for taking legs off tables. Rental trucks usually have tie-down rails or slats along the walls. Check where they are before you start.

Lay a few pads on the floor at the front. The front wall of the cargo box is also called the nose, and on many trucks there's an overhang above the cab sometimes called "mom's attic." It's a good spot for fragile, light boxes that you want out of the way.

The loading order

Experienced crews build tiers. A tier is a slice of the load running across the full width of the truck, from floor to ceiling, about two to four feet deep. Each one gets finished and tied off before the next one starts.

Work in this rough order:

  1. Heaviest and largest items against the front wall: refrigerator, washer, dryer, piano, dressers, bookcases. Keep weight low and toward the front, centered from side to side, so the truck handles better.
  2. Long tall pieces stood upright along the side walls: headboards, mattresses in bags, sofa cushions, table tops, mirrors in cartons.
  3. Fill the gaps in each tier with heavy boxes on the bottom and lighter ones on top. Books and dishes go low. Bedding and lampshades go high.
  4. Soft items like bags of linens, pillows and stuffed toys get pushed into the empty spaces to lock things in place.
  5. Strap off the tier, then start the next one against it.

Sofas usually go on end, standing up, wrapped in pads. A loveseat on end takes surprisingly little floor area. Upholstered chairs can sit seat-to-seat or on top of a solid dresser with a pad in between.

Protecting furniture

Every wooden or finished surface that touches another hard surface needs a pad. Wrap dressers and tables fully, then secure the pads with stretch wrap or tape on the pad, not on the furniture. Tape pulls finish off wood.

Remove legs from tables when they come off easily. Put screws and bolts in a zip bag and tape it to the underside of the piece it came from. Pull dresser drawers or wrap the dresser so they can't slide open. Light, soft contents can stay in the drawers; heavy ones make the piece hard to carry and stress the frame.

Glass tabletops and mirrors travel best in picture boxes or between two pieces of cardboard, standing on edge, never flat. Mark them so nobody stacks against the glass side.

Tie-offs and the last tier

Use a strap or rope across each tier every few feet of truck length. Run it from rail to rail at about two-thirds the height of the tier. You aren't trying to crush anything. You're just keeping the face of the tier from tipping backward.

The last tier at the door is the one that falls out when the door goes up at the other end. Pack it as tightly as the others and strap it. If you have a ramp, slide it back in before you strap the last tier so it doesn't block the load.

Keep a small space at the very end for things you'll need first at the new home: a toolbox, cleaning supplies, a box of bathroom basics, and the bed hardware bag. Or keep those in your car.

Weight and balance

Rental trucks have a payload limit printed on the door frame or in the rental agreement. A household rarely exceeds it, but a garage full of tools, a gun safe and a few thousand books can get close. If in doubt, spread the very heaviest items between the front and the middle, still low and centered.

Don't stack heavy boxes on top of furniture with thin tops, like a desk or a nightstand. Use the furniture as a shelf only when the top is solid wood or reinforced.

What doesn't go in the truck

Don't load propane tanks, gasoline, paint thinner, pool chemicals, aerosols in bulk, or anything else flammable or corrosive. Rental companies prohibit hazardous materials, and so do most moving crews. Drain fuel from lawn mowers and other small engines.

Keep valuables, documents and medications with you. The same goes for houseplants on a hot day, and pets, which should never ride in the cargo area.

At the other end

Unload in reverse, but don't just drop things in the first room. Put a sign on each door at the new place that matches the room labels on your boxes, and stand someone at the entrance to point the crew where things go. Furniture should go to its final spot and stay there. Moving a dresser twice costs the same as moving it the first time if you're paying by the hour.

If you're booking labor for the load or the unload, the movers and hours estimator gives a rough crew size and time for your home, and suggests a truck size so you don't rent one that's too small.

Questions

Should a mattress go in a moving truck flat or on its side?

On its side, standing up against the wall or a flat tier of furniture, in a mattress bag. It takes less floor space that way and acts as padding for what's next to it. Don't put heavy boxes on top of a mattress lying flat.

How full should a moving truck be?

As full as possible from front to back, with every tier packed tight to the ceiling. A half-empty truck with gaps lets loads shift on turns and braking. If you'll have space left, pull the last tier forward and strap it rather than spreading things out.